We've launched the new forums! Read more here

Shaft adapter ?

Nippon Shafts
Barberakb

Barberakb

USAF / Go Cowboys!
Joined
Aug 8, 2010
Messages
6,000
Reaction score
65
Location
Las Cruces NM
Handicap
15
I'm sure this has been asked but I can't find it.

Can you use a .350 adapter in a .335 shaft or vice versa.
I'm guessing you can't do this reliably but I just wanted to make sure.

Thanks.
 
you can shim a .335 shaft to fit a .350 adapter, but going the other way requires sanding/shaving that can really weaken the tip.
 
For most adjustables, you can buy an aftermarket adapter that would allow you to use a .350 shaft in a .335 head. The sections where the shaft connects to the adapter is .350 and the narrows to .335 where the adapter connects to the driver. The other way around you could shim or simply buy the correctly sized aftermarket one. Check Golfsmith or Billy Bob's for example.

Barberakb said:
I'm sure this has been asked but I can't find it.

Can you use a .350 adapter in a .335 shaft or vice versa.
I'm guessing you can't do this reliably but I just wanted to make sure.

Thanks.
Click to expand...
 
The correct size is readily available so might be best to get the correct size check Flea Bay
 
Brianbigoats said:
The correct size is readily available so might be best to get the correct size check Flea Bay
Click to expand...

I wish, according to Cobra the only ones that they sell are .335.
I can't find any .350, even on ebay for the amp cell. All are .335 even the Chinese knockoffs...
 
You must log in or register to reply here.
Back
Top