Wedge shaft help!!!

Ok so I'm in the process of changing my wedges going with atv 50 and 54! They come stock with a kbs wedge shaft which I just can't seam to control dispersion all over the place!

Im under the impression that this is a reg flex shaft am I correct?

I play project x 6.5 in my irons so there is a huge difference!

I will hit full shots with my 50 and a mix of shots with my 54!

My question to you guys is do I put a 6.5 In my 50 then something like a black nickel wedge stiff in my 54 or do I go with kbs black nickel wedge stiff in both?

I'm open to suggestions guys

Iv got a dg spinner in my 58 which I like but hated it in everything else!!

The wedge flex aren't reg flex. But if you're used to 6.5, I'd put that in both new wedges. Move away from the 58* and spinners! put the wedge down....

Haha i dont mind the 58 and spinner combo! Im just not sure about the 6.5 in the wedges might go a flex softer

I believe the KBS labeled "Wedge" shaft on the ATV should be 6.1 and 120g. The chatty guy on the pop up window at TM site said it was KBS Wedge Stiff. It has a firm tip for me as I don't balloon it at all.