jscincy
Member
Just in case anyone was interested I decided to regrip mine. So I took a few pics to help anyone else out if you were wanting to do this as well....
I unscrewed the ball off the back counter clockwise, came off pretty easy when chucked into the vise.
Used a 1/2" drill bit too slowly drill a hole in back of the new grip to allow the threaded rod through the back..
Cut off old grip which had no tape... I added tape for new grip..
Then installed new grip as usual... I reinstalled the ball using a little Teflon plumbing tape...
Hope it may help someone in the future...
Thanks
I unscrewed the ball off the back counter clockwise, came off pretty easy when chucked into the vise.
Used a 1/2" drill bit too slowly drill a hole in back of the new grip to allow the threaded rod through the back..
Cut off old grip which had no tape... I added tape for new grip..
Then installed new grip as usual... I reinstalled the ball using a little Teflon plumbing tape...
Hope it may help someone in the future...
Thanks