c0ncept
SFT
- Joined
- Aug 8, 2011
- Messages
- 8,508
- Reaction score
- 20
- Location
- Renton, WA, United States
- Handicap
- Life
So I originally got these club heads and they had this shaft in them. I just put it in one and while it fits snugly at the tip but it wobbles a little on the sides farther up. They heads are .355 as are the shafts. I am wondering if they might have been drilled out a little? (It looks like a quarter of an inch from the opening is wider) Is that gap on the sides an issue? I tried a .370 shaft and it didn't go in more than a cm. I was looking to put .355 shafts back into them.