dthrog00
Well-known member
I think the Dynamic Golds I have in my irons may be too heavy and I'd benefit from using graphite. I'd plan to reshaft 4-GW and a 56* wedge that I have. Reputable shops around me cost $20/club for the service and once you add shafts + grips I would be better off buying new clubs as my irons are not expensive.
The useful tools I already have are an air compressor and electric drill with bits.
I'd be happy to take advice from anyone who has experience with the tooling and supplies necessary. I've watched some McClub videos to get some background.
Shaft removal:
Heat gun is $30 at Golfworks. I also saw a Youtube video where a guy used his stove top also, but I'm married and think my wife would wish bodily harm on me if I tried this.
Might need a knife to remove the ferrule although I think I can improvise and figure something out for this step.
Prep:
Brush bit to clean out the hosel, I need to figure out what this is. I might be able to use a drill bit as an alternative?
Rod saw bit for hacksaw and masking tape to cut the shafts, will probably get from hardware store. Get shafts back to square with sandpaper.
Sand paper to prep the shaft.
Assembly:
Need shafts, grips, and ferrules.
Epoxy, 50 mL cartridge is $6.49 @ GW.
Sand paper and acetone for the ferrule
Grips:
Plan to use air compressor, don't have a vice so will need to figure out how to support the club.
Thoughts/comments?
Dave
The useful tools I already have are an air compressor and electric drill with bits.
I'd be happy to take advice from anyone who has experience with the tooling and supplies necessary. I've watched some McClub videos to get some background.
Shaft removal:
Heat gun is $30 at Golfworks. I also saw a Youtube video where a guy used his stove top also, but I'm married and think my wife would wish bodily harm on me if I tried this.
Might need a knife to remove the ferrule although I think I can improvise and figure something out for this step.
Prep:
Brush bit to clean out the hosel, I need to figure out what this is. I might be able to use a drill bit as an alternative?
Rod saw bit for hacksaw and masking tape to cut the shafts, will probably get from hardware store. Get shafts back to square with sandpaper.
Sand paper to prep the shaft.
Assembly:
Need shafts, grips, and ferrules.
Epoxy, 50 mL cartridge is $6.49 @ GW.
Sand paper and acetone for the ferrule
Grips:
Plan to use air compressor, don't have a vice so will need to figure out how to support the club.
Thoughts/comments?
Dave