Super Tuna
You can't scale this!
Evening Gents,
With a standard stepless putter shaft in a plumbers neck setup, that's usually a .355 taper tip that's required right? I think this goes for Betti's, Mills, Cameron's, etc
Also I'm not sure if this is possible due to how the RST is, but does anyone know if it's possible to swap the shaft in a Seemore DB4 and which tip size if would require if you could?
Cheers!
With a standard stepless putter shaft in a plumbers neck setup, that's usually a .355 taper tip that's required right? I think this goes for Betti's, Mills, Cameron's, etc
Also I'm not sure if this is possible due to how the RST is, but does anyone know if it's possible to swap the shaft in a Seemore DB4 and which tip size if would require if you could?
Cheers!