Ok so I decided to take this on. 5-AW. Before I go and epoxy them up I’m asking for confirmation that I did everything correct. Went KBS Tour 90 and followed trim instruction to point. From my fitting they should be 1/2” Long, check. I have the heads weighted so they are all 7-8 gms apart. Swing weight is recommended D4. I’m getting D4 5-8 and D5 9-AW. Am I good to go? Will I notice the difference? What is more important swing weight or consistency between weight of heads? I defer to anyone that has more experience than me and has any advice on where I’m at.
Thanks in advance.
Sent from my iPhone using Tapatalk
Thanks in advance.
Sent from my iPhone using Tapatalk
Last edited: