scottmti
Passionate Hacker
I like to clarify soft stepping parallel irons.
This question is for irons already been built and pulling the shaft out.
For taper shaft pull 5i shaft and use it on 6i and it makes 1/3 softer. Simple enough.
What about the parallel shaft? Since parallel shaft flex is adjusted by length of tip trimming does it work like taper shaft? Use 5i shaft on 6i makes it softer or it doe make any difference?
Thanks
Sent from my iPhone using Tapatalk
This question is for irons already been built and pulling the shaft out.
For taper shaft pull 5i shaft and use it on 6i and it makes 1/3 softer. Simple enough.
What about the parallel shaft? Since parallel shaft flex is adjusted by length of tip trimming does it work like taper shaft? Use 5i shaft on 6i makes it softer or it doe make any difference?
Thanks
Sent from my iPhone using Tapatalk