Hi all. I am looking for some recommendations from this wonderful community for driver shafts. I had a combined lesson/driver fitting yesterday because my pro thought my current setup was a problem. Here's what I have:
2014 Big Bertha 10.5*
Fubuki ZT 60 Stiff
Standard Length
I began having trouble keeping the ball flight down. Trackman was able to pinpoint a swing issue which was great and should help, but the pro and fitter (obviously) both think I need something different. The shaft that seemed to fit best was a Diamana B Series 70...not sure if it was S or X but I'm assuming S. My swing speed is apparently between 100-105 with my current setup, and got up in 106-110 with the Diamana and a 9.5* R15 head. I generated about 3500 RPM spin consistently with my current setup and the ball goes WAY too high and doesn't roll an inch after landing.
I don't feel like spending $800+ on a custom driver. An alternative he recommended was the "chinese" version of the shaft (didn't catch the name) combined with a 9.5* SLDR head, which is more palatable, but if there's similar, less expensive options I'm all ears. I'm also still not sold that my BB head wouldn't be sufficient after changing shafts.
Before I pull the trigger on ANYTHING I'm working on the issue with my swing, but I do seem to still spin the hell out of the ball when I do it right, albeit to much better results.
Anyway...any suggestions would be great. Thanks!
2014 Big Bertha 10.5*
Fubuki ZT 60 Stiff
Standard Length
I began having trouble keeping the ball flight down. Trackman was able to pinpoint a swing issue which was great and should help, but the pro and fitter (obviously) both think I need something different. The shaft that seemed to fit best was a Diamana B Series 70...not sure if it was S or X but I'm assuming S. My swing speed is apparently between 100-105 with my current setup, and got up in 106-110 with the Diamana and a 9.5* R15 head. I generated about 3500 RPM spin consistently with my current setup and the ball goes WAY too high and doesn't roll an inch after landing.
I don't feel like spending $800+ on a custom driver. An alternative he recommended was the "chinese" version of the shaft (didn't catch the name) combined with a 9.5* SLDR head, which is more palatable, but if there's similar, less expensive options I'm all ears. I'm also still not sold that my BB head wouldn't be sufficient after changing shafts.
Before I pull the trigger on ANYTHING I'm working on the issue with my swing, but I do seem to still spin the hell out of the ball when I do it right, albeit to much better results.
Anyway...any suggestions would be great. Thanks!