We've launched the new forums! Read more here

Question on Parallel Tip & Taper Tip

Nippon Shafts
JFlores

JFlores

Active member
Joined
Mar 12, 2013
Messages
1,633
Reaction score
6
Location
Golf Course
Handicap
18.8
I tried looking but could not find a definitive answer, I am in the market for shafts, could anyone confirm the following:

X Hot - taper or parallel
Callaway MD2 Wedges - taper or parellel

Thanks!
 
Taper on both .335
JFlores said:
I tried looking but could not find a definitive answer, I am in the market for shafts, could anyone confirm the following:

X Hot - taper or parallel
Callaway MD2 Wedges - taper or parellel

Thanks!
Click to expand...
 
JFlores said:
Sorry should of said X Hot irons??
The wedges would be .355 correct.

Sorry for the redundant questions.
Click to expand...
Yes taper tip .355
 
Just a hint, when I buy iron/wedge shafts I always buy .355 because they can easily be shimmed into .370, but you obviously can't put .370 into a .355 without some serious work.
 
I thought I read that the irons were .370, site also showed (ptip). Was just a bit confused.
 
JFlores said:
I thought I read that the irons were .370, site also showed (ptip). Was just a bit confused.
Click to expand...

I am finding that the XHots are .370, but the XHP are .355. You might hit up Harry on Twitter and ask him to be sure, but like I said before if you order .355 then you dont have a problem either way because the club builder can just put shims in them to make them fit in the .370
 
That sounds correct. X hot irons are .370 P while the MD2 wedges are .355 TT
 
Are the 14 X Forged .355 taper as well?
 
You must log in or register to reply here.
Back
Top