Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
I've watched this twice now. Looking forward to putting into practice soon with an Attas Coool headed my way. One tip I picked up on was attaching the head to the adapter before install. I always thought it was done by just putting the adapter on the shaft.
Less than 5 minutes and you can start reshafting your own clubs. Seems like a solid time investment. Danny Le is the reason I was able to do a complete reshaft of my irons, he's a great teacher.
All it took was a bit of bribery with a free trip...haha
Great stuff by Danny as usual. I've done some reshafting myself and the only devil in the details I still need to work out is getting the SW right without all the nasty lead tape.
Danny makes this look so easy. I do my own grips, but I have not tried to install my own shafts. Part of the reason is that I do not have the tools or experience to take the old shafts out. I would like to try this in my garage at some point and get some experience with the process. I feel it would be much more fulfilling knowing that you hand built your own clubs! Great video, thanks.
Start with steel. That way you'll get a feel for how much heat you need to apply to break the epoxy bond. Plus you don't need a shaft puller for steel. Just jump in and give it a go, buy some thrift store sticks if you have to just to practice on.
Lead tape is indispensable. Just don't lick your fingers after you're done working with it
Joking aside, sometimes you need some extra mass and lead tape is the quick and dirty. Aside from that it's tip weights or lead/tungsten powder.
Honestly had always assumed that the adapter was installed on the shaft without the head being installed to the adapter. That seems much much easier to do with the head attached.
When you are installing shafts on drivers Danny, is your preference graphics up or down, or no preference at all?
Sounds like you have a full sweet set up; maybe you'll be able to swap the Recoils into some 718s soonHe does it all the time. it's not that hard TBH. Once you have all the equipment & supplies, it's a piece of cake. I just ordered a swing weight scale to complete my shop. Especially since I have some Recoils heading my way thanks to Danny. :banana:
Honestly had always assumed that the adapter was installed on the shaft without the head being installed to the adapter. That seems much much easier to do with the head attached.
When you are installing shafts on drivers Danny, is your preference graphics up or down, or no preference at all?