miparman
Member
Reading all the rave XR16 driver reviews I'm thinking about pulling the trigger but the same old issue keeps popping up in my mind.
I HATE and just cannot get along with drivers at these longer lengths (45.75" in the XR's case). So in reading the looong XR16 driver thread I would assume all are not playing them at the stock lengths.
That said at my preferred length of 44.5" with a 53 gram Bassara P Series shaft and in trying to achieve a decent D2 or 3 sw with a +1/32" grip the sw issue becomes a problem.
So the only alternative is hot melt as to add that much lead tape is not a good solution.
My question is are all playing at less than stock lengths using hot melt or what?
I HATE and just cannot get along with drivers at these longer lengths (45.75" in the XR's case). So in reading the looong XR16 driver thread I would assume all are not playing them at the stock lengths.
That said at my preferred length of 44.5" with a 53 gram Bassara P Series shaft and in trying to achieve a decent D2 or 3 sw with a +1/32" grip the sw issue becomes a problem.
So the only alternative is hot melt as to add that much lead tape is not a good solution.
My question is are all playing at less than stock lengths using hot melt or what?