The_PharmASSIST
Medicinal Mulligans
Hey guys,
I just had all my clubs re-gripped with Lamkin Crosslines (love them by the way) by my local range. They said that the clubs had been sitting about an hour or so after they finished the installation before I picked them up. I then decided to hit some balls on the range with them.
After I finished up I noticed some solvent leaking out of the top hole in the grips that hadn't dried yet. I don't think I caused any problems by using them, the end cap was slightly twisted on one which I was able to move back into place. The end-caps are all properly seated.
While none of the grips appeared to move off the shaft, does my using them increase the chance that the adhesive will fail or move later on?
Thanks for the help!
I just had all my clubs re-gripped with Lamkin Crosslines (love them by the way) by my local range. They said that the clubs had been sitting about an hour or so after they finished the installation before I picked them up. I then decided to hit some balls on the range with them.
After I finished up I noticed some solvent leaking out of the top hole in the grips that hadn't dried yet. I don't think I caused any problems by using them, the end cap was slightly twisted on one which I was able to move back into place. The end-caps are all properly seated.
While none of the grips appeared to move off the shaft, does my using them increase the chance that the adhesive will fail or move later on?
Thanks for the help!