JF
New member
- Joined
- Oct 21, 2011
- Messages
- 6,672
- Reaction score
- 41
I want to customize my putter myself. I've done a good bit of searching around but haven't really found a great description of exactly how the refinishing process is done step by step. I'm thinking along the lines of Playdough's custom SeeMore. Here's what I have right now:
1. Remove shaft by heating hosel and gently pulling it out when the epoxy softens.
2. Remove paintfill
3. Use a fine sandpaper to remove scratches on the putter.
Then it comes time to actually apply a new finish. How many coats of what kinds of paints need be used? How would I go about perfecting this part? If I were to stamp the putter would I do it before or after applying the finish?
5. Paintfill
6. Re-apply shaft or apply new Vibrant shaft if I do that.
7. Regrip.
1. Remove shaft by heating hosel and gently pulling it out when the epoxy softens.
2. Remove paintfill
3. Use a fine sandpaper to remove scratches on the putter.
Then it comes time to actually apply a new finish. How many coats of what kinds of paints need be used? How would I go about perfecting this part? If I were to stamp the putter would I do it before or after applying the finish?
5. Paintfill
6. Re-apply shaft or apply new Vibrant shaft if I do that.
7. Regrip.