Galen Marek
Well-known member
We know there's tolerances in the equipment industry and that the COR limit is .830. What I've always wondered is does each driver sold hit that .830 mark or are some .820, .825, .832, etc.
If you knew your driver fell short of .830 and it was economically feasible (I have no idea what that costs) would you have your driver brought to the legal limit via face shaving? Or if you found it was over the legal limit would the manufacturer be obligated to replace it?
If you knew your driver fell short of .830 and it was economically feasible (I have no idea what that costs) would you have your driver brought to the legal limit via face shaving? Or if you found it was over the legal limit would the manufacturer be obligated to replace it?